HID Global Corporation X001800C Manual De Usuario
©
2010
HID
Global
Corporation
All
rights
reserved
Troubleshooting with the Error Message Table
Error Message
Cause
Solution
# 44
Flipper Jam/ Home
Error
Error
|contextid=220
A card has become
jammed in the Printer’s
Flipper Table.
jammed in the Printer’s
Flipper Table.
The Flipper failed to
position properly while
aligning a card or flipping a
card.
position properly while
aligning a card or flipping a
card.
Clear any cards in the Flipper Table
using the buttons to move the card
out. Resume printing.
using the buttons to move the card
out. Resume printing.
• Reset the Printer and retry. If
problem persists call for technical
assistance.
assistance.
# 45
No Flip Module
|contextid=221
Request to print on 2
nd
side
of card, but no Flipper is
installed.
installed.
If a Flipper Module is present,
ensure that the Print Both Sides
option in the Printer Driver is set
correctly.
ensure that the Print Both Sides
option in the Printer Driver is set
correctly.
• Install a Flipper module.
# 48
Check Lam Power
|contextid=281
Lam is connected but not
powered.
powered.
Power off the Printer, power the
Laminator, and then power on the
Printer. A damaged Flipper board,
E-Card board, or EEPROM could
potentially result in this same error.
Laminator, and then power on the
Printer. A damaged Flipper board,
E-Card board, or EEPROM could
potentially result in this same error.
# 52
Lam Generic Error
|contextid=280
Laminator firmware error
Cycle power and try again.
• If this problem persists call for
technical assistance.
DTC4500 Card Printer/Encoder User Guide
84