Trimble Inc. 45145-5800 Manual De Usuario
5800 GPS Receiver User Guide 1 3 1
Setting up the Receiver 1 2
55800 O
p
era
tion
12.3.2
Sources of Electrical Interference
Avoid the following sources of electrical and magnetic noise:
•
Gasoline engines (spark plugs)
•
Televisions and PC monitors
•
Alternators and generators
•
Electric motors
•
Equipment with DC-to-AC converters
•
Fluorescent lights
•
Switching power supplies
12.3.3
General Guidelines
The following guidelines apply whenever you set up your receiver for
operation:
operation:
•
When plugging in a Lemo cable, make sure that the red dots on
the receiver port and the cable connector line up. Never use
force to plug cables in, as this may damage the connector pins.
the receiver port and the cable connector line up. Never use
force to plug cables in, as this may damage the connector pins.
•
When disconnecting a Lemo cable, grasp the cable by the
sliding collar or lanyard and pull the cable connector straight
out of the port. Do not twist the connector or pull on the cable
itself.
sliding collar or lanyard and pull the cable connector straight
out of the port. Do not twist the connector or pull on the cable
itself.
•
To securely connect a TNC cable, align the cable connector
with the receiver receptacle, then thread the cable connector
onto the receptacle until it is snug.
with the receiver receptacle, then thread the cable connector
onto the receptacle until it is snug.
•
To insert the internal battery (PN 38403) place the battery in the
battery compartment, ensuring that the contact points are in the
correct postion to align with the contacts in the receiver. Slide
the battery and compartment as a unit upward into the receiver
until the battery compartment latches are locked into position.
battery compartment, ensuring that the contact points are in the
correct postion to align with the contacts in the receiver. Slide
the battery and compartment as a unit upward into the receiver
until the battery compartment latches are locked into position.