Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Trimble Inc.
  4. 5580090
  5. Manual De Usuario

Trimble Inc. 5580090 Manual De Usuario

Descargar
Página de 152
6     Configuring the SPSx50 Using the Keypad and Display
64     SPSx50 Modular GPS Receiver User Guide
5.
Press 
G  
 
to enter Edit mode for the format.
6.
Press 
J  
 
or 
K 
 
to change which correction message will be output on the port.
7.
Press 
L  
 
to accept the change.
8.
Press 
L  
 again. 
9.
Use the NMEA screen to set up NMEA outputs from the receiver. Press 
L  
 
to 
accept the default of no NMEA messages. 
10. Use the GSOF screen to set up GSOF outputs from the receiver. Press 
L  
 
to 
accept the default of no GSOF messages. 
11. Use the RT17 screen to set up RT17 outputs from the receiver. Press 
L  
 
to 
accept the default of no RT17 messages. The Home screen appears and the base 
setup is complete. 
Configuring the SPSx50 as a rover receiver
You can use the Trimble SCS900 Site Controller software or the receiver keypad to set 
up the SPSx50 base receiver. 
The receiver is configured step by step to ensure that all appropriate settings are 
configured. To move between steps in the configuration process, press 
L  
.
Configuring the receiver 
1.
In the Home screen, press 
L  
. Use the Operation Mode screen to configure 
system settings, mode settings, or to view the SV (satellite) status. Mode Settings 
is the default setting.
2.
Press 
L  
. Use the Mode screen to select whether the receiver will operate as a 
base or rover.
3.
Press 
G  
. When the mode begins to flash, the receiver is in Edit mode and you 
can change this setting.
4.
Press 
K 
 
to change to Rover.
5.
Press 
L  
 
to accept the change.
6.
Press 
L  
 
again to move to the Elevation mask and RTK mode screen. See next.
Changing the elevation mask and RTK mode
1.
Press 
G
 . When the value for the current elevation mask begins to flash, the 
receiver is in Edit mode and you can change the setting.
2.
Press 
K 
 
to change the elevation mask to the required value.
Note – Trimble recommends that you do not set the elevation mask to a value lower than 
10 degrees.
3.
Press 
L  
 
to accept the change.