Trimble Inc. WCSNM941 Manual De Usuario
SNM941 Connected Site Gateway Installation Guide |
4
1
Safety Information
Before you use the Trimble® SNM941 Connected Site® Gateway, ensure that you have read and
understood all safety requirements.
understood all safety requirements.
C
WARNING –
This alert warns of a potential hazard which, if not avoided, could result in severe
injury or even death.
C
CAUTION –
This alert warns of a potential hazard or unsafe practice that could result in minor
injury or property damage or irretrievable data loss.
NOTE –
An absence of specific alerts does not mean that there are no safety risks involved.
C
CAUTION –
The operating temperature range is –30° C to +85° C and the storage temperature
range is –40° C to +85° C. Exceeding these ranges may cause damage to the unit, machine, and
the operator.
the operator.
Installing antennas
C
CAUTION –
If wiring around the negative master disconnect, the antenna mount must be
electrically isolated from the asset’s chassis ground.
C
CAUTION –
For your own safety, and to comply with the RF Exposure requirements of the FCC,
always observe these precautions:
– Do not locate antenna within 20 cm of any other transmitting antenna, to avoid co-location
issues.
– Do not locate antenna within 20 cm of any other transmitting antenna, to avoid co-location
issues.
Wiring notices
C
CAUTION –
Wiring around a master disconnect switch, if installed, may void the warranty of the
machine or equipment. Refer to the machine or device user manual and warranty information. If it
is deemed necessary to wire around this switch and directly to battery a 5 A fuse must be
installed on the Battery Negative line of the harness.
is deemed necessary to wire around this switch and directly to battery a 5 A fuse must be
installed on the Battery Negative line of the harness.
DRAFT