Trimble Inc. WCSNM941 Manual De Usuario
SNM941 Connected Site Gateway Installation Guide |
7
1
1
Introduction
Welcome to the SNM941 Installation Guide. This document describes how to install and verify initial
operation of the SNM941.
operation of the SNM941.
It is necessary, even for an experienced installer, to review this entire manual in order to become familiar
with the special features that differentiate the SNM941 from any other telematics device. If you are not
familiar with GNSS or vehicle telematics, visit the Trimble website (
with the special features that differentiate the SNM941 from any other telematics device. If you are not
familiar with GNSS or vehicle telematics, visit the Trimble website (
www.trimble.com
) for an interactive
look at Trimble and these technologies.
About the SNM941 device
The Trimble® SNM941 device comes in two models. The SNM941-60 supports cellular communications
in all regions excluding the Americas (but including Brazil). The SNM941-90 supports cellular
communications in the Americas (excluding Brazil). Both variants offer GNSS positioning, cellular
communications, wireless LAN communications, Ignition sense, Engine On sense, three digital inputs,
one analog input, and wired communications using CANbus, RS-232, and Ethernet.
in all regions excluding the Americas (but including Brazil). The SNM941-90 supports cellular
communications in the Americas (excluding Brazil). Both variants offer GNSS positioning, cellular
communications, wireless LAN communications, Ignition sense, Engine On sense, three digital inputs,
one analog input, and wired communications using CANbus, RS-232, and Ethernet.
The Trimble SNM941 devices are designed to operate reliably in very harsh installation environments
including all types of heavy construction equipment. These devices can be installed in-cab or out-of-cab.
If the host asset has an electronic control module (ECM) installed somewhere, the SNM941 can be
installed in that same location, but not in the engine compartment.
including all types of heavy construction equipment. These devices can be installed in-cab or out-of-cab.
If the host asset has an electronic control module (ECM) installed somewhere, the SNM941 can be
installed in that same location, but not in the engine compartment.
Related information
Sources of related information include the following:
•
Support Notes – Product support notes describe new features of the product, information not
included in the installation guide, and information on machine model-specific installation. They are
available from Trimble Support (see below) and the Trimble Civil Engineering and Construction Sales
team. Support notes are updated as firmware updates are released.
included in the installation guide, and information on machine model-specific installation. They are
available from Trimble Support (see below) and the Trimble Civil Engineering and Construction Sales
team. Support notes are updated as firmware updates are released.
•
Trimble training courses – Consider a training course to help you use your GNSS telematics system
to its fullest potential. For more information, go to the Trimble website at
to its fullest potential. For more information, go to the Trimble website at
.
DRAFT