Benq Corporation WDR02U Manual De Usuario
Communications Commission ofthe U.S. Government.
The exposure standard employs a unit of measurement known as the SpecificAbsorption Rate, or SAR. The SAR limit set
by the FCC is 1.584 W/kg. Tests for SARare conducted using standard operating positions accepted by the FCC with
theEUT transmitting at the specified power level in different channels.The FCC has granted an Equipment Authorization
for this device with all reportedSAR levels evaluated as in compliance with the FCC RF exposure guidelines.
SARinformation on this device is on file with the FCC and can be found under theDisplay Grant section of
www.fcc.gov/oet/ea/fccid.
To ensure that RF exposure levels remain at or below the tested levels, use a beltclip, holster, or similar accessory that
have no metallic component in the assembly.
To ensure that RF exposure levels remain at or below the tested levels, use a beltclip, holster, or similar accessory that
have no metallic component in the assembly.
This device has been tested and meets the FCC RF exposure guidelines. The maximum SAR value
reported is 1.584w/kg.
IC Radiation Exposure Statement for Canada
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference. (2) This device must accept any interference,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference. (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux
CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
This device complies with RSS 210 of Industry Canada. This Class B device meets all the
requirements of the Canadian interference-causing equipment regulations.
requirements of the Canadian interference-causing equipment regulations.
Cet appareil numérique de la Classe B respecte toutes les exigences du Règlement sur le matériel
brouilleur du Canada.
brouilleur du Canada.
The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful
interference to co-channel mobile satellite systems.
interference to co-channel mobile satellite systems.
les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une
utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de
satellites mobiles utilisant les mêmes canaux.
CAN ICES‐3(B)/NMB‐3(B)
This EUT is compliance with SAR for general population/uncontrolled exposure limits in IC RSS‐102 and
had been tested in accordance with the measurement methods and procedures specified in IEEE 1528.
To maintain compliance with ISED RF exposure requirements, use only belt‐clips, holsters or similar
accessories that does not contain metallic components in its assembly. The use of accessories that do
not satisfy these requirements may not comply with ISED RF exposure requirements and should be
This EUT is compliance with SAR for general population/uncontrolled exposure limits in IC RSS‐102 and
had been tested in accordance with the measurement methods and procedures specified in IEEE 1528.
To maintain compliance with ISED RF exposure requirements, use only belt‐clips, holsters or similar
accessories that does not contain metallic components in its assembly. The use of accessories that do
not satisfy these requirements may not comply with ISED RF exposure requirements and should be