Hughes Network Systems 24HX-001 Manual De Usuario

Before you can install the outdoor equipment, the mast must be
installed.

The mast must have an outside diameter of 2.0 to 4.5 inches (5.0
to 11.4 centimeters) and must be securely mounted in a vertical or
horizontal position. If the mast is not installed, you will need to
install it before you proceed. For additional details concerning
the mast, see the AIReach Broadband Hub and Remote Terminal
Site Preparation Guide.

Before starting, make sure you have:

•

Antenna mount

•

Antenna

•

Transceiver

•

3/8–inch torque wrench with 13–millimeter deep socket

•

5/32–inch (4–millimeter) hex key wrench

 You will also need the following tools to plot HT alignments:

•

Detailed local map – Must show true north, streets,
buildings, and landmarks. It is helpful if the map shows
magnetic declination, or magnetic north versus true north. A
U.S. Geological Survey map is recommended. A travel map
will suffice if it shows sufficient detail.

•

Ruler or straight edge

•

Protractor with markings from 0

°

 to 180

°

.

•

Pencil or broad–tip pen

•

Compass

•

Chalk or other marker to mark lines on the roof

•

Optional: chalked plumb line (the type you snap to
leave a straight chalk line)

Unpack the ODU transceiver and antenna before going up to the
roof. Carry the transceiver and antenna to the roof (in separate
trips) in a backpack or padded bag. Make sure the transceiver or
antenna is secured in the backpack or bag.