Hughes Network Systems 24HX-001 Manual De Usuario
1027145 – 0001 Revision E
4–10 Installing ODUs
Hub installation
The antenna mount (HNS 1029056–0005) is shipped
fully assembled. Figure 4-5 shows an exploded view to show all
the parts. However, you do not need to take the mount apart to
install it, unless you need to reverse the mast clamp. (The mast
clamp is reversible, as explained later.)
fully assembled. Figure 4-5 shows an exploded view to show all
the parts. However, you do not need to take the mount apart to
install it, unless you need to reverse the mast clamp. (The mast
clamp is reversible, as explained later.)
Figure 4-5
Antenna mount
Antenna
bracket
Mast clamp
(rear part of antenna mount)
(rear part of antenna mount)
Mast interface
(front of
antenna
mount)
Mast
Mast interface - detail
Azimuth locking nuts
(2, top and bottom)
(2, top and bottom)
Elevation
locking nuts (2)
locking nuts (2)
Antenna bracket
locking nuts (4)
locking nuts (4)
Fine azimuth
adjuster
adjuster
Fine
elevation
adjuster
elevation
adjuster
Mast clamp nuts (4)
T0006056
HT
alignment
direction
(to
ward
assigned
sector)
The antenna mount design allows you to install and tighten the
mount and antenna and then adjust the antenna azimuth and
elevation without loosening the mount or antenna. Parts of the
mast interface move to allow these adjustments.
mount and antenna and then adjust the antenna azimuth and
elevation without loosening the mount or antenna. Parts of the
mast interface move to allow these adjustments.
4.4
Preparing to install
the antenna mount
the antenna mount