Radicom Research Inc RB9500 Manual De Usuario
RB9500
Designer’s
Guide
(01-30-16)
21
Important Regulatory Compliance and User Information
The final product with the modules installed needs to be tested for FCC Part 15, IC (Industry
Canada) CE, EMI/RFI compliance. Radicom certification documentation will help
streamline the final product approval process. Contact Radicom for more information. To
maintain compliance in the finished product, carefully follow guidelines in this section. This
device is intended only for OEM integrators under the following condition:
The transmitter module may not be co-located with any other transmitter or antenna. As long
as this condition is met, further transmitter testing will not be required. However, the OEM
integrator is still responsible for testing their end product for any additional compliance
requirements required with the module installed (for example, digital device emissions, PC
peripheral requirements, etc). IMPORTANT NOTE: In the event that this condition cannot
be met then the FCC authorization is no longer considered valid and the FCC ID cannot be
used on the final product. In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
Host (End Product) Labeling Requirements
The final end product must be labeled in a visible area with the following:
" Contains TX FCC ID: K7T-RB9500 ".
RB9500
is for the model of the module used in the end equipment. The label shall be
securely affixed to a permanently attached part of the device, in a location where it is visible
or easily accessible to the user, and shall not be readily detachable. The label shall be
sufficiently durable to remain fully legible and intact on the device in all normal conditions
of use throughout the device’s expected lifetime. These requirements may be met either by a
separate label or nameplate permanently attached to the device or by permanently imprinting
or impressing the label directly onto the device. The label text shall be legible without the aid
of magnification, but is not required to be larger than 8-point font size.
End User Information