Garmin AT Inc. AT7000 Manual De Usuario
Installation Manual
Equipment Removal and Replacement
560-0405-00 Rev –
December 14, 2001
December 14, 2001
Page 35
© 2001 by UPS Aviation Technologies Inc.
Section 5 - Equipment Removal and Re-
placement
5.1 Removal
5.1.1
Transponder
Remove the transponder from the tray with ARINC 600 hold-downs as follows:
1. Loosen unit hold-down knobs.
Figure 12 – Removal of Unit from Tray
2. Pull out and down to release the knob from the hook of component.
3. Slowly pull forward on unit handle to separate unit and tray connectors. Transponder
is now free to be removed from mounting tray. Place electrostatic protective covers
over transponder connector and aircraft mating electrical connector.
over transponder connector and aircraft mating electrical connector.
5.2 Replacement
5.2.1
Transponder
Replace the transponder in mounting tray as follows:
1. Remove protective plastic covers from aircraft connectors. Remove electrostatic
protective covers from transponder connectors.
2. Slide transponder into mounting tray.
CAUTION:
DO NOT FORCE FIT. IF MATING IS DIFFICULT, REMOVE THE
TRANSPONDER AND CHECK FOR CONNECTOR PINS THAT
MAY BE BENT OR OUT OF ALIGNMENT. ALSO, CHECK THE
ALIGNMENT OF THE RECEPTACLE IN MOUNTING TRAY.
TRANSPONDER AND CHECK FOR CONNECTOR PINS THAT
MAY BE BENT OR OUT OF ALIGNMENT. ALSO, CHECK THE
ALIGNMENT OF THE RECEPTACLE IN MOUNTING TRAY.