Crestron Electronics Inc CEN-RFGW-EX Manual De Usuario

This document was prepared and written by the Technical Documentation department at: 

 

 

 

Crestron Electronics, Inc. 

15 Volvo Drive 

Rockleigh, NJ 07647 

1-888-CRESTRON

 

 

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device

may not cause harmful interference and (2) this device must accept any interference received, including interference that

may cause undesired operation.

CAUTION:  Changes or modifications not expressly approved by the manufacturer responsible for compliance could

void the user's authority to operate the equipment.

NOTE:  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver   is

connected.

Consult the dealer or an experienced radio/TV technician for help.

Operation is subject to the following two conditions:

1.

This device may not cause interference, and

2.

This device must accept any interference, including interference that may cause undesired operation of the device.

To satisfy RF exposure requirements, this device and its antenna must operate with a separation distance of at least
20 centimeters from all persona and must not be co-located or operating in conjunction with any other antenna or
transmitter.

Shielded LAN cable must be used.

 

All brand names, product names and trademarks are the property of their respective owners. 

©2009 Crestron Electronics, Inc.