Crestron Electronics Inc CWD1015 Manual De Usuario
Two-Way RF Transceiver Module
Crestron CWD1015
6
• Two-Way RF Transceiver Module: CWD1015
Operations Guide - DOC. 6659
Setup
Hardware Hookup
Refer to the hookup diagram below, which shows the connections made to the
module. Complete the connections in any order.
module. Complete the connections in any order.
NOTE: To prevent unit-to-unit RF interference, multiple modules operating at the
same frequencies should not be installed within three to five feet of each other.
same frequencies should not be installed within three to five feet of each other.
Hookup Connections for CWD1015
ANTENNA:
TRANSMITS
AND RECEIVES
RF SIGNALS
POWER-I/O:
PROVIDES
POWER AND
SYSTEM
INTERFACE
For more information on these connectors, refer to “Ports” on page 3.
End Product Labeling
The final end product must be labeled in a visible area with the following: “Contains
FCC ID: EROCWD1015 .
FCC ID: EROCWD1015 .
Documentation
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the users manual of the end
product which integrate this module.
regarding how to install or remove this RF module in the users manual of the end
product which integrate this module.
The users manual for OEM integrators must include the following information in a
prominent location
prominent location
“IMPORTANT NOTE: To comply with FCC RF exposure
compliance requirements, the antenna used for this transmitter
must be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.”
compliance requirements, the antenna used for this transmitter
must be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.”