Crestron Electronics Inc CWD1016 Manual De Usuario

15 Volvo Drive   Rockleigh, NJ 07647 

Tel: 888.CRESTRON 

Fax: 201.767.7576  

Specifications subject to  

www.crestron.com 

change without notice. 

“Contains Transmitter Module FCC ID: EROCWD1016” 

or  

“Contains FCC ID: EROCWD1016”  

The OEM of the CWD1016 Module must only use the approved antenna, which has 
been certified with this module. 

The OEM of the CWD1016 Module must test their final product configuration to 
comply with Unintentional Radiator Limits before declaring FCC compliance per 
Part 15 of the FCC rules. 

IMPORTANT NOTE:  In the event that these conditions cannot be met (for 
example co-location with another transmitter), then the FCC authorization is no 
longer considered valid and the FCC ID cannot be used on the final product. In these 
circumstances, the OEM integrator will be responsible for reevaluating the end 
product (including the transmitter) and obtaining a separate FCC authorization. 

Refer to the /I-O Pinout Signals table which shows the connections made to the 
module. 

NOTE:  To prevent unit-to-unit RF interference, multiple modules operating at the 
same frequencies should not be installed within three to five feet of each other.  

The module is provided with an internal antenna. 

The module has an edge connector for surface mounting to a printed circuit board 
(PCB). 

The final end product must be labeled in a visible area with the following: “Contains 
FCC ID: EROCWD1016 . 

The OEM integrator has to be aware not to provide information to the end user 
regarding how to install or remove this RF module in the users manual of the end 
product which integrate this module. 

The users manual for OEM integrators must include the following information in a 
prominent location