Crestron Electronics Inc CWD7041 Manual De Usuario
Two-Way RF Transceiver Module with Integral Antenna
Crestron CWD7041
2
Two-Way RF Transceiver Module with Integral Antenna: CWD7041
Operations Guide - DOC. 7263A
Specifications
The table below is a summary of specifications for the CWD7041.
Specifications of the CWD7041
SPECIFICATION DETAILS
Power Requirements
0.22 Watts (3.3VDC @ 0.067A)
Operating Frequency
2400 MHz to 2483.5 MHz (802.15.4 compliant)
Operating Ranges*
Minimum
Distance
Maximum Distance Outdoors
(without repeater device)
(without repeater device)
3 ft
550 ft
Available Channels
16 (numbered 11 through 26 per 802.15.4)
Serial Communication
SPI, 3.3V Nominal
Dimensions
Width:
1.25 in (3.18 cm)
Height: 1.57 in (4.00 cm)
Depth: 0.50 in (1.27 cm)
*
The location and orientation of the module are important factors in the RF performance. With the unit located outside
of any metal enclosures, the antenna is adjusted to achieve the best range. The range is dependent on its placement and
the building in which it is used. The construction of the building, obstructions, and RF interference from other devices
are factors determining the effective range of the unit. To prevent unit-to-unit RF interference, multiple modules
operating at the same frequencies should not be installed within 3-5 feet of each other.
of any metal enclosures, the antenna is adjusted to achieve the best range. The range is dependent on its placement and
the building in which it is used. The construction of the building, obstructions, and RF interference from other devices
are factors determining the effective range of the unit. To prevent unit-to-unit RF interference, multiple modules
operating at the same frequencies should not be installed within 3-5 feet of each other.
Physical Description
The module, shown below, consists of various components attached to a printed circuit board. An
antenna is attached to the circuit board while a 25-pin header is for the application-specific installation.
antenna is attached to the circuit board while a 25-pin header is for the application-specific installation.
Physical View of CWD7041