DEI Headquarters Inc. HYU1800 Manual De Usuario
Page-25
PROGRAMMING
Entering programming options
1. Enter programming mode (see page 24)
⎯ the antenna embedded LED will stay on for up to 20 seconds.
2. Before the LED turns off, press and hold the brake pedal.
3. Press one of the following buttons:
LOCK
......................................... to access option 1;
UNLOCK
..................................... to access option 2; or
START/STOP
.............................. to access option 3.
4. Release the brake pedal.
Programming options
* INDICATES DEFAULT SETTING
Engine Run Time
OPTION 1* Run Time = 3 minutes
OPTION 2
Run Time = 8 minutes
OPTION 3
Run Time = 15 minutes
Remote starter tachometer learning procedure
Multi-speed tach programming
1. Enter programming mode (see page 24)
⎯ the antenna embedded LED will stay
on
for up to 20 seconds.
2. Before the LED turns off, press and hold the brake pedal and press the
LOCK
and
UNLOCK
buttons of the remote
starter transmitter simultaneously
⎯ the LED will flash 4 times. At that point, release the brake pedal and
LOCK
and
UNLOCK
buttons.
3. Start up the engine and allow the vehicle to reach regular engine idle speed.
4. Once the engine is running at normal idle speed, press the brake pedal and keep it down until you hear the remote
starter module click 5 times.
5. Release the brake pedal
⎯the tach programming is now complete.
Virtual Tach System (VTS)
VTS is able to effectively monitor the engine starting sequence and release the starter at the right time without physically
connecting the Tach wire of the remote starter to the vehicle.
connecting the Tach wire of the remote starter to the vehicle.
IMPORTANT NOTICE
Special VTS programming procedure for vehicles with no
Tach wire.
Ensure that the vehicle hood is OPEN:
Tach wire.
Ensure that the vehicle hood is OPEN:
• Press and hold the PAB button for 4 seconds
• Release the PAB button (the antenna LED will turn ON)
• While the antenna LED is on, press the PAB button once more and
release immediately
• You now have 20 seconds to press and release the brake pedal 6 times
(rapidly)
• The parking lights will flash 8 times, confirming the reset
• Remote starter is now in VTS mode, you can continue with programming