Bird Technologies Group 61470A Manual De Usuario
Bird Technologies Manual 7-9558-2.3 05/14/15 Page 28
Channel Module Replacement
The SBIII channel module is field replaceable. Fol-
low the steps listed below in sequential order. The
required tools are a 5/32” hex head driver.
low the steps listed below in sequential order. The
required tools are a 5/32” hex head driver.
1) Turn off power to the signal booster.
2) Disconnect the 6 VDC power cable. The power
input cable is located at the top of the module
next to the LED indicators.
next to the LED indicators.
3) Disconnect the COM cable. The COM cable is
located at the top of the module next to the LED
indicators. There may be one or two COM
cables depending on the boosters configura-
tion. It is important to re-attach the correct COM
cable to the correct plug so it is a good idea to
mark the cables as you remove them from the
module so as to avoid confusion later during re-
installation.
indicators. There may be one or two COM
cables depending on the boosters configura-
tion. It is important to re-attach the correct COM
cable to the correct plug so it is a good idea to
mark the cables as you remove them from the
module so as to avoid confusion later during re-
installation.
4) Remove the control cable. The control cable is
located at the bottom of the module and has a
white plastic pull tab on it.
white plastic pull tab on it.
5) Disconnect the downlink and uplink RF cables.
6) Remove the 12 hold down screws (5/32” hex
head) that hold the channel module assembly
to the cabinet. The screw heads are accessible
from the heatsink side of the assembly. Refer to
Figure 25.
to the cabinet. The screw heads are accessible
from the heatsink side of the assembly. Refer to
Figure 25.
7) Remove the assembly by pulling it away from
the cabinet.
8) To install the replacement channel module
reverse steps 7 through 2. When replacing the
RF cables do not overtighten the SMA connec-
tors. They should be tightened just slightly more
than hand tight or to the specification of 7 in/lbs.
The channel module assembly comes with an
O-ring gasket which must press up against the
outside of the cabinet firmly and squarely in
order to provide a correct moisture seal.
RF cables do not overtighten the SMA connec-
tors. They should be tightened just slightly more
than hand tight or to the specification of 7 in/lbs.
The channel module assembly comes with an
O-ring gasket which must press up against the
outside of the cabinet firmly and squarely in
order to provide a correct moisture seal.
Control Module Replacement
The SBIII Control Module is field replaceable. Fol-
low the steps listed below in sequential order. The
required tools are a 5/16” nut driver, a #2 Phillips
screwdriver, and a small flat blade screwdriver
(jewelers screwdriver).
low the steps listed below in sequential order. The
required tools are a 5/16” nut driver, a #2 Phillips
screwdriver, and a small flat blade screwdriver
(jewelers screwdriver).
1) Turn off power to the signal booster.
Figure 25: Remove mounting screws to detach channel module from cabinet.
Remove Screws
Remove Screws
Remove
Screws
Remove
Screws