B+B SmartWorx THINQ1 Manual De Usuario

Quatech SDS User’s Manual

Configuring the SDS using a Web interface

Step

Procedure

Description

Note: Setup screens vary slightly between
RS-232 and RS-232/422/485 (MEI) units.
If you have an RS-232/422/485 (MEI) SDS,

the Configure Serial Port Interface step will
display so that you can select between RS-

232 and RS-422/485 operation.
If you have an RS-232 SDS, the Configure
Serial Port Interface step will not display

and you will not be presented with any RS-
422/485 configuration options.

Note: Click on a link to see a pop-up help
screen for that item. For example, if you

click on the Normal Mode link, the
following help screen pops up.

Figure 53 - Serial Port Setup screen for Normal mode

Note: Click on a link
to see a pop-up help
screen for that item.

Step

Procedure

Description

Step 1

Click on the serial port you want to

configure.

Clicking on a port number highlights

and selects that port. The selections on

the screen are automatically populated
with the parameters for the selected port.

Step 2

Click on the Normal Operating Mode

selector.

Select Normal mode if you are using the

Quatech virtual COM port drivers or
IntelliSock SDK.
You will find directions for configuring

ports in Tunneling, Raw TCP, Auto
TCP, and Raw UDP modes in the

following sections.

Step 3a

Configure the Operating mode.
Click on the desired data Rate Multiplier.
Your choices are:

Auto (Recommended)

Force X2 mode

The auto setting has no effect on the

baud rate you set. However, if you select
X2, X4, or X8, the baud rate of the serial

port will be the baud rate that you set

multiplied by 2, 4, or 8, respectively.

March 2005

940-0183-151

Page 53