B+B SmartWorx THINQ1 Manual De Usuario
Configuring the SDS using a Web interface
Quatech SDS User’s Manual
UDP has three possible modes of communication that you select
according to the IP/UDP address you enter:
¾
Point to point – key in a specific device’s address to communicate
only with that device
¾
Broadcast – key in the broadcast address of 255.255.255.255 to
send to all devices listening for the transmission
send to all devices listening for the transmission
¾
Multicast – key in an address in the assigned UDP range of
224.0.0.0 – 239.255.255.255 to send to several devices with the
224.0.0.0 – 239.255.255.255 to send to several devices with the
selected address
Step
Procedure
Description
Preliminary
Step
Select Serial Ports from the selection
bar.
Note: Setup screens vary slightly between
RS-232 and RS-232/422/485 (MEI) units.
If you have an RS-232/422/485 (MEI) SDS,
the Configure Serial Port Interface step will
RS-232 and RS-232/422/485 (MEI) units.
If you have an RS-232/422/485 (MEI) SDS,
the Configure Serial Port Interface step will
display so that you can select between RS-
232 and RS-422/485 operation.
If you have an RS-232 SDS, the Configure
If you have an RS-232 SDS, the Configure
Serial Port Interface step will not display
and you will not be presented with any RS-
422/485 configuration options.
422/485 configuration options.
The Serial Port Setup screen shown on
the following page displays.
Note: Click on a link to see a pop-up help
screen for that item. For example, if you
screen for that item. For example, if you
click on the Raw UDP link, the following
help screen pops up.
help screen pops up.
Page 66
940-0183-151
March 2005