B+B SmartWorx WLNG1 Manual De Usuario
Operate the All-in-One
23
NOTE:
There are two ways to clear the bar code or symbol and prepare the All-in-One to scan again:
Press the yellow CLEAR button. The red tail lights will flash once and the All-in-One will emit a
tone.
tone.
Wait for the All-in-One to time out and erase the scan from the memory. The All-in-One will
emit a Hi-Lo tone and the red tail lights will flash once.
emit a Hi-Lo tone and the red tail lights will flash once.
Scanning tips
The All-in-One's scanner is similar to a digital camera in that it takes digital pictures of a bar
code. Like a digital camera, the scanner should be held as still as possible when reading a bar
code.
code. Like a digital camera, the scanner should be held as still as possible when reading a bar
code.
The green light bar should be approximately centered on the bar code.
The green light bar should cover approximately 3/4 of a wide linear bar code.
The All-in-One is capable of reading bar codes at a distance of from 2 - 12 inches, but 6 - 9
inches is the ideal range. Actual reading distances may vary depending on the dimensions of
the bar code.
inches is the ideal range. Actual reading distances may vary depending on the dimensions of
the bar code.
Reading bar codes straight on is appropriate in many cases, but the reflected light can interfere
with reading. Holding the All-in-one at an angle of about 5 degrees to the bar code may give
better results.
with reading. Holding the All-in-one at an angle of about 5 degrees to the bar code may give
better results.
The All-in-One reads bar codes in an omnidirectional manner. This means the All-in-One does
not need to be pointed in the same direction as the bar code.
not need to be pointed in the same direction as the bar code.
The green light bar should be approximately centered
on the bar code and cover approximately 3/4 of a
wide bar code
on the bar code and cover approximately 3/4 of a
wide bar code
The All-in-One reads bar codes in an omnidirectional
manner
manner