Forward Electronics Co Ltd 4K3FDA-18N1 Manual De Usuario

quickly)

iii.

Press the mouse ‘ID’ button to connect with receiver(the LED will flash quickly)

iv.

When finished the procedure, then the RF keyboard and mouse can be operated

like general keyboard and mouse.

4. Troubleshooting: Keyboard/mouse do not work.

Check the batteries

ii.

Check the receiver’s cable connections.

iii.

Press the connect button on the receiver, then press the connect button on the

keyboard and mouse. (To ensure the connection is probably, please check the

distance between receiver and keyboard/mouse is under 1.0 meters)

iv.

Maker sure the USB port has the proper configuration. Refer to your computer

documentation for correct port configuration. You may also have other system

devices for conflicts. Please change the setting as required.

Warranty: Limited warranty of twelve months is provided by manufacture since the date of

produced.

FCC Requirements Radio & Television Interference

This device complies with Part 15 FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference. (2) This device must accept

any interference received including interference that may cause undesired operation."

Warning: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy, and if not installed and used in

accordance with the instructions, may cause harmful interference to radio communication.

However,, there is no equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

1). Reorient or relocate the receiving antenna.

2). Increase the distance between the equipments and receiver.

3). Connect the equipment into a separate power outlet from which the receiver is connected.

4). Consult the dealer or an experienced radio/TV technician for soulation.

Note:

1. The changes or modifications not expressly approved by the party responsible for

compliance could void the user authority to operate the equipments.

2. Shielded interface cable and A.C. power cord, if any, must be used in order to comply

with the emission limits.