Digital Security Controls Ltd. 01NB9010 Manual De Usuario
S ec ti o n 2 . 1 : P r o g r a m m i n g th e N T 9 01 0
1 7
4. If you want to use a recorded label, in place of the first word of the label enter
[244], then the number of the label [001] to [005]. The recorded label will
replace all six words in the section. To record a label, see Recording Custom
Labels on page 17.
replace all six words in the section. To record a label, see Recording Custom
Labels on page 17.
5. When you have entered the label, the system will recite it. If the label is correct,
press [#]. To change the label, repeat steps 1-4, above.
6. Record the new label in the appropriate section of the Programming Work-
sheets.
Adding Numbers to Labels
Three special Number Commands are available to allow the system to include a
number in the voice label. The number commands allow the system to announce
the number in three different modes:
Three special Number Commands are available to allow the system to include a
number in the voice label. The number commands allow the system to announce
the number in three different modes:
Label 000: Number Command 1, Combined Form. The number will be
announced in its full form. For example, the number 401 would be announced as
“four hundred and one”.
announced in its full form. For example, the number 401 would be announced as
“four hundred and one”.
Label 001: Number Command 2, Ordered Form. The number will be announced
in a descriptive form. For example, the number 401 would be announced as “four
hundred and first”.
in a descriptive form. For example, the number 401 would be announced as “four
hundred and first”.
Label 002: Number Command 3, Individual Numbers. Each digit in the number
will be announced individually. For example, the number 401 would be announced
as “four zero one”.
will be announced individually. For example, the number 401 would be announced
as “four zero one”.
The number commands take up two of the six available word spaces in a label. In
the first space select the type of announcement for the number (Number Com-
mand 000, 001 or 002). In the second space program the 3-digit number to be
read (from 000 to 999).
the first space select the type of announcement for the number (Number Com-
mand 000, 001 or 002). In the second space program the 3-digit number to be
read (from 000 to 999).
NOTE:
Because number commands take up 2 label spaces, you cannot
program them in the sixth entry spot for a label.
Recording Custom Labels
You can record up to five custom labels for the system and for the zones using pro-
gramming sections [701] to [705]. You can use any of these labels for the system or
zone labels, instead of the words available in the Audio Label Library. To record a
custom label:
You can record up to five custom labels for the system and for the zones using pro-
gramming sections [701] to [705]. You can use any of these labels for the system or
zone labels, instead of the words available in the Audio Label Library. To record a
custom label:
1. From Advanced Programming, enter [807].
2. Enter one of sub-sections [701] to [705].
3. Press the Record function key on the NT9010.
2. Enter one of sub-sections [701] to [705].
3. Press the Record function key on the NT9010.
4. Speak into the NT9010 microphone. Each label can be up to 1.5 seconds long.
To stop recording, press [#].
5. When you are finished recording, press the Playback function key. The NT9010
plays your recorded label back to you. To listen to the label again, press Playback
again.
again.
6. If you want to re-record the label, press the Record function key again.
7. To record more labels, repeat steps 1 to 5.