Digital Security Controls Ltd. 09LC151 Manual De Usuario

 

10 

 

 

Terminal 1 - Marked “+” (+12V) - Connect to a positive Voltage of 9.6 -16Vdc source 

(usually from the control panel)  

Terminal 2 - Marked “-” (GND) - Connect to the ground of the control panel. 

Terminals 3 & 4 - Marked “TAMPER” - If a Tamper function is required connect these 

Terminals to a normally closed 24-Hour Tamper Zone on the control panel.  

If the top cover of the detector is opened or the detector is detached from installation wall, an 

immediate alarm signal will be sent to the control panel. 

Terminal 5 - Marked “EOL” - End of line – optional terminal for end of line resistors 

connections.  

Terminals 6, 7 & 8 - Marked “NC / C / NO” - These are the output relay contacts of the 

detector. Connect to a zone input on the control panel. When an intruder is detected, alarm 

relays (N.C. and N.O.)  will switch for 1.8 sec. 

Use #22 AWG or larger wires. Use the following table to determine required wire gauge and 

length. 

Wire Length [m]    

205 

310 

510 

870 

Wire Length [ft.]    

800 

1200 

2000 

3400 

Wire Gauge [#]      

22 

20 

18 

16