Digital Security Controls Ltd. 12TR5164 Manual De Usuario

Enrollment consists of programming the device’s Electronic Serial Number (ESN) into the TR5164 so 

that it can be identified when an event is communicated. The ESN is located on the back of each 

wireless device.

NOTE: When programming via hardwired keypad, wireless key programming sections 001-064 

and 101-116 only accept 6 digits. To program 8-digit ESNs, only use the last 6 digits.
This section describes how to enroll and program:

• wireless devices using zones

• wireless keys 

For more information on these devices, read the instruction sheet included with each device.

The TR5164 features three LEDs to help with the installation of devices and troubleshoot the operation 

of the unit. In normal operation, the LEDs indicate if the signal received is from an enrolled device.

• The green LED flashes when receiving a signal from an enrolled device.

• The red LED flashes when receiving a signal from a non-enrolled device.

• The yellow LED flashes when interference is detected.

Alternatively, when the panel is in placement test mode, the green LED only flashes for the specific 

serial number entered. All other signals (including signals from valid enrolled devices) flash red.

During initial power up of the alarm panel, a 2-minute window is established for enrolling the wireless 

keypad (indicated by flashing AC Power and Ready LEDs). If the enrollment window expires, power 

down the panel then power up again to re-open.

To enroll a keypad:

1. Power up alarm system.

2. Power up keypad. After a few seconds, “Hold [1] and [

,

] to Enroll Keypad” is displayed on the 

LCD.

3. Press the [

,

] and [1] keys simultaneously to enroll the keypad. “WFKP Enrollment Successful” is 

displayed.

If the “Failed to Enroll” message is displayed, perform the following:

• Retry the enrollment.

• Reposition the keypad closer to the control panel.

• Verify that the READY and POWER LED indicators are flashing on the panel. If not, disconnect 

the panel from AC and DC power sources then reconnect.

• Check for RF interference. 

1. Enter [

,

][8][Installer Code][898]. The following is displayed: “Wireless Enrollment Mode.”

2. Activate the device as indicated below. 

• Keypad: Press the [

,

] and [1] keys simultaneously.

• Wireless key: Press any key to activate.

• Detectors (PIR, Smoke, Glass break): Press the Tamper button.

• Repeater: Press the Tamper button. Note: Ensure that dip switch 3 on the repeater is in the off 

position before quick enrolling a repeater.

3. The Electronic Serial Number (ESN) is displayed on the keypad. Press [

,

] to confirm the ESN. If 

the ESN is incorrect, press [#] then repeat step 2.  

DRAFT