ADC Telecommunications Inc. PSM1900M Manual De Usuario
Power on the RF Module
FlexWave Prism RF Modules for Prism Remote Units Installation Guide
Page 45
TECP-77-141 Issue 5 • 300001744178 Rev E • November 2013
© 2013 TE Connectivity Ltd.
Power on the RF Module
1
Follow the rules listed below to toggle the Power switch that corresponds to the RF Module
to its ON position.
to its ON position.
•
For Dual‐Slot RF Modules, use the Power switch for the lower module. For example, to
power up a Dual‐Slot RF Module in combined slots C+D in a Quad‐Bay chassis, turn ON DC
Power switch for Mod C; leave the DC Power switch for Mod D OFF.
power up a Dual‐Slot RF Module in combined slots C+D in a Quad‐Bay chassis, turn ON DC
Power switch for Mod C; leave the DC Power switch for Mod D OFF.
•
A Dual‐Slot 40W RF Module uses the Power Supplies in both slots. If the Dual‐Slot 40W RF
Module is installed in slots C+D, turn ON the Power switch for Mod C and Mod D.
Module is installed in slots C+D, turn ON the Power switch for Mod C and Mod D.
2
Repeat all the steps in
to install other RF Modules.
MOD A
SeRF
Module
AC Power
switch for
switch for
Remote
chassis
DC Power switch for Mod A
DC Power switch for Mod B
DC Power switch for Mod C
DC Power switch for Mod D
MOD B
MOD C
MOD D