Badger Meter Inc 2012WCE Manual De Usuario

3.  Using the charts below, connect the ORION Universal 1 endpoint to an approved encoder according to the following  

guidelines. Verify the endpoint serial number prior to completing the wiring set up.

Due to the customized, factory wire configurations of the Hersey Translator, please contact Hersey to determine the 

terminal post wiring schematic for your encoders. Once the terminal post information is determined, use the Sensus 

ECR 11, OCE wiring directions below. 

NOTE: The terminal posts and wire colors may not match.

ORION CE Endpoints (Serial Number > 80,000,000) or ORION SE and ME Endpoints                

Red

R

B

G

G

B

B

Black

B

G

B

B

G

B

Green

G

R

R

R

R

G

 

ORION CE Endpoints (Serial Number < 79,999,999)

Red

R

B

G

R

B

Black

B

G

B

B

B

Green

G

R

R

G

G

 

R = 

Red

            B = Black           G = 

Green

 

*A separate ORION CE endpoint is available for connectivity to the Neptune ARB-V encoder.

4.  Connect the encoder cable wires to the ORION Universal endpoint wires using the insulation gel connectors  

provided in the installation kit. Refer to the chart to determine which wires need to be connected to complete an 

installation. The ORION system was designed as a three-wire AMR system only. 

 

Do not strip any insulation from the ends of the wires before you push them into the connector.

5.  Push the wires that are to be connected together as far as possible into the connector.

Page 18

                   5-11