Badger Meter Inc 2014GWGAL Manual De Usuario
GALAXY® II Gateway Receiver
Banding Mounting
Banding mounting equipment is sized to mount the gateway on a 2-1/2…24-inch outer diameter pole .
IMPORTANT
When using the banding mounting kit for the network gateway receiver, use BAND-IT® Idex installation practices. Refer to
for more information. This is especially applicable when
mounting on a non-tapered vertical pole, as the banding could loosen over time resulting in the unit sliding down the pole.
To mount the gateway on a pole, gather the banding and locking equipment .
Figure 8: Banding and locking equipment
OTE:
N
Installation of banding mounting kit requires use of the BAND-IT tool shown below (66042-006) or equivalent
BAND-IT tool as recommended by BAND-IT .
Figure 9: BAND-IT tool
Page 12
February 2014