Badger Meter Inc REPEAT Manual De Usuario
11
16. As soon as you are done programming
an ORION
®
Repeater, it is important to
turn off your Programming Accessory.
Turn off the Programming Accessory by
properly positioning the Badger
Turn off the Programming Accessory by
properly positioning the Badger
®
-Radix
®
Data Collector on to the Programming
Accessory and selecting the [Stop
Radio] <T> button.
Accessory and selecting the [Stop
Radio] <T> button.
NOTE: To erase all ORION serial
numbers in the repeater, program the
numbers in the repeater, program the
Program Accessory to a transmitter
number of ‘0’ and place the ORION
Repeater in programming mode using
the steps above.
number of ‘0’ and place the ORION
Repeater in programming mode using
the steps above.
To verify all ORION transmitter serial
numbers in the repeater, swipe the
magnet across the programming
location on the ORION Repeater.
BE CERTAIN THAT THE
PROGRAMMING ACCESSORY IS
EITHER TURNED OFF OR NOT IN
RANGE OF THE ORION REPEATER
PRIOR TO SWIPING THE MAGNET
ACROSS THE PROGRAM LOCATION.
numbers in the repeater, swipe the
magnet across the programming
location on the ORION Repeater.
BE CERTAIN THAT THE
PROGRAMMING ACCESSORY IS
EITHER TURNED OFF OR NOT IN
RANGE OF THE ORION REPEATER
PRIOR TO SWIPING THE MAGNET
ACROSS THE PROGRAM LOCATION.
SPECIFICATIONS
Power Source “C” size lithium battery
Construction Monitor housed in a
NEMA 4 plastic enclosure
Dimensions
Weight 5.5
oz
Environmental Indoor or non-submersed
outdoor
Temperature -40°F to 140°F (-40°C to
60°C)
Humidity 0% to 95%, non-
condensating
REGULATORY
This device complies with Part 15 of FCC
rules. Operation is subject to:
rules. Operation is subject to:
(1) this device may not cause harmful
interference
(2) this device must accept any
interference, including interference
that may cause undesired operation
that may cause undesired operation