Visonic Inc. MCT241MDRL Manual De Usuario
DE2294RLU
3
4. MISCELLANEOUS COMMENTS
4. MISCELLANEOUS COMMENTS
4. MISCELLANEOUS COMMENTS
4. MISCELLANEOUS COMMENTS
4.1 Product Limitations
Our wireless systems are very reliable and are tested to high
standards. However, due to their low transmitting power (required
by FCC, DTI and other regulating authorities) there are some
limitations to be considered:
A. Receivers may be blocked by radio signals on or near their
standards. However, due to their low transmitting power (required
by FCC, DTI and other regulating authorities) there are some
limitations to be considered:
A. Receivers may be blocked by radio signals on or near their
operating frequencies, regardless of the code selected.
B. A receiver can only respond to one transmitted signal at a time.
C. Wireless equipment should be tested regularly (at least once
C. Wireless equipment should be tested regularly (at least once
a week) to determine if there are sources of interference and
to protect against faults.
to protect against faults.
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for compliance, could void
the user's authority to operate the equipment.
approved by the party responsible for compliance, could void
the user's authority to operate the equipment.
4.2 Battery Handling
Since the product has a Lithium battery, please observe the
following handling instructions:
following handling instructions:
•
Do not dispose of batteries in fires
•
Do not short circuit
•
Observe correct polarity of cells
•
Do not crush
•
Do not puncture
•
Do not open
•
Do not dismantle
•
Do not expose to temperatures in excess of 60
°
C
ATTENTION! The internal Lithium battery can be replaced in
the factory only.
the factory only.
4.3 Compliance with Standards
The 315 MHz version of this device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
This
FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
This
device must accept any interference received, including
interference that may cause undesired operation.
WARNING! Changes or modifications to this unit not
expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
The digital circuit of this device has been tested and found to
comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in residential
installations. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio and television reception. However, there is no guarantee
that interference will not occur in a particular installation. If this
device does cause such interference, which can be verified by
turning the device off and on, the user is encouraged to eliminate
the interference by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the
comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in residential
installations. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio and television reception. However, there is no guarantee
that interference will not occur in a particular installation. If this
device does cause such interference, which can be verified by
turning the device off and on, the user is encouraged to eliminate
the interference by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the
one which supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.