Shenzhen Yitoa Intelligent Control Co. Ltd. 300082 Manual De Usuario
15
Maintenance
WARNINg: Disconnect the
power before attempting any
maintenance or cleaning to
reduce the risk of fire, electric
shock or damage to persons.
Light Bulb Replacement
Allow at least five (5) minutes
for the light bulbs to cool before
touching them to avoid accidental
burning of the skin. The light
bulbs need to be replaced when
you notice a dark section of
the flame or when the clarity
and detail of the log ember bed
exterior reduces. There are three
(3) bulbs under the log set, which
generate the flames and embers,
and two (2) bulbs above the log
that illuminate the log exterior.
Helpful Hints: It is a good
Helpful Hints: It is a good
idea to replace all light bulbs at
one time if they are close to the
end of their rated life. Group
replacement will reduce the
number of times you need to
open the unit to replace light
bulbs. Care must be taken when
removing the log set as the log
set contains LED’s and wires.
Lower Light Bulb Requirements
Quantity of three (3) clear
Lower Light Bulb Requirements
Quantity of three (3) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
60 Watt rating. Example: GE
60BC or Philips 60 CTC.
Do not exceed 60 Watts per
Do not exceed 60 Watts per
bulb.
To access the lower light bulb
To access the lower light bulb
area:
slide fireplace out of mantel.
1.
Lay unit on it’s back for safe
2.
removal of front glass.
Remove four (4) Phillips
Remove four (4) Phillips
3.
screws from the right side of
trim.
Lower
Bulbs
Upper
Bulbs
Trim
Front
Glass
Log set
Figure 7
Back
Ledge
Log
Ember bed
Rear
Tab
Front
Edge
side section
Figure 8