Climax Technology Co Ltd 862 Manual De Usuario

 

3



  Installation Guideline 



 

The PIR Camera is designed to be mounted on either a flat surface or in 
a corner situation with fixing screws and plugs provided. 



 

The  base  has  knockouts,  where  the  plastic  is  thinner,  for  mounting 
purpose. Two knockouts are for surface fixing and a triangular mounting 
bracket is used for corner fixing. 



 



 

Mount  where  the  animals  cannot  come  to  the  detection  area  by 

climbing on furniture or other objects. 



 

Don’t aim the detector at stairways the animals can climb on. 



 

In a position such that an intruder would normally move across the PIR’s field of view. 



 

Between 1.9 and 2m above ground for best performance. When mounted at 1.9 meters above ground, it 
gives a typical PET IMMUNE range of 7 meters. As the PIR Pet-Immune Camera is higher from above 
ground, it gives a farther PET IMMUNE range. 



 

In a corner to give the widest view. 



 

Where its field of view will not be obstructed e.g. by curtains, ornaments etc. 



 

For a small 3 to 5m room, install between 1.9 to 2m above ground. 



 



 

Do not install the PIR Camera completely exposed to direct sunlight. 



 

Avoid installing the PIR Camera in areas where devices may cause rapid change of temperature in the 

detection area, i.e. air conditioner, heaters, etc. 



 

Avoid large obstacles in the detection area. 



 

Not pointing directly at sources of heat e.g. Fires or boilers, and not above radiators. 



 

Avoid moving objects in the detection area i.e. curtain, wall hanging etc. 



 

Be sure to always remain the RSSI signal strength steady at “4”. 



  Mounting the PIR Camera 



 

1.  Open the cover by loosening the Cover Screw using a Philips screwdriver. 
2.  Break through the 2 Surface knockouts at the center of base. 
3.  Use the holes as template to drill holes on the surface. 
4.  Insert the wall plugs if fixing it into plaster or brick. 
5.  Screw the base into the wall plugs. 
6.  Fit the cover onto the base and tighten. 



 

1.  Break through the two knockouts on the triangular bracket. 
2.  Use the two holes as template to drill holes on the corner surface. 
3.  Insert the wall plugs.   
4.  Screw the triangular bracket into the wall plugs with the two pointing 

sticks on top facing you. 

5.  Fit the PIR Camera onto the hooks of the triangular bracket. 

 

This  device  complies  with  Part  15  of  the  FCC  Rules.  Operation  is  subject  to  the  following  two 
conditions: 
(1)  This  device  may  not  cause  harmful  interference,  and  (2)  This  device  must  accept  any 
interference received, including interference that may cause undesired operation.