DTC Communications Inc. HVT250-S Manual De Usuario
DTC COMMUNICATIONS, INC.
5
QUICK START
Handheld Video Transmitter,
Rear View (Antenna position shown for
reference only. Adjust antenna position
for best performance.)
O-Ring Lubricant
Charging the HVT battery pack
(external method):
A. Make sure the Main Power Switch is in the center position.
B. Loosen and remove the front bezel.
C. Grasp black plastic ring and carefully pull out assembly.
D. Unplug 13-pin Hirose connector and fully remove assembly.
E. Unplug DC power connector, loosen Velcro straps and replace battery
pack with a fully charged spare (at least 3 hours charging time).
Charging the HVT battery pack
(internal method):
F. Turn the HVT Main Power Switch to OFF (center).
G. Attach the Battery Charging cable to the Ext. Power Input Connector.
H. Connect AC Charger unit to proper power source.
(The battery will charge at a slower rate when the HVT is powered from the Ext. DC Power Conditioner.)
J. Charge the HVT battery pack for at least three hours.
Reassembly Tips
•
Align external and internal switches to center position to prevent
damage to switch.
damage to switch.
•
Keep threads, O-ring groove, and inside lip of bezel lubricated with
Silicone Grease.
Silicone Grease.
•
Screw together firmly. Periodically check O-ring for damage.
BATTERY CHARGER:
ORANGE = CHARGING,
FLASHING GREEN or ORANGE = CHARGING TOP OFF,
GREEN = CHARGED
FLASHING GREEN or ORANGE = CHARGING TOP OFF,
GREEN = CHARGED
WARNING: Make sure the Main Power Switch is in the center
position during disassembly and reassembly or damage to the
switch may occur.
position during disassembly and reassembly or damage to the
switch may occur.