DTC Communications Inc. PD2TX1000SV Manual De Usuario

4

1. 

Connect the transmitter antenna to the SMA connector on the Palladium unit.

2. 

If you plan to use audio, connect one or two microphones to the Audio 1 and/or Audio 2 
LEMO connectors. If using monaural, use Audio 1.

3. 

Connect power and video input via the Multi I/O cable to the 6-pin Hirose connector:

 

  a. Attach your camera video input (75 ohm composite video source in PAL or NTSC) to   

 

      the Multi I/O cable BNC connector.     

 

 

  b. Apply the necessary power to your camera (use supplied cable or external source) and  

 

      turn ON.

 

  c. Attach a 12 VDC power source to the Multi I/O cable via the Molex connector. The   

 

      input voltage range is from 10 to 16 VDC. 

 

 

WARNING: Do not apply power to the transmitter unless an antenna or non-radiating 
load is connected to the Antenna SMA connector.

Typical Wiring Configuration

 A2 
  L

 A1 
R/M

Palladium Transmitter, Top View 

Proper heat sink mounting is recommended for optimal performance. See page 8 for heat 
sinking instructions.