Seiko Epson Corporation AP003 Manual De Usuario
Setting a Pace and
Measuring (Target Pace
Function)
Measuring (Target Pace
Function)
If you fall behind the pace set as the target pace during
measuring, an alarm sounds.
measuring, an alarm sounds.
When you fall behind the target pace, you can set a range
for the alarm for completing your target time (target
pace) of around one kilometer.
for the alarm for completing your target time (target
pace) of around one kilometer.
♪
♪
♪
c
Important:
❏ When performing GPS positioning, make sure
the screen is facing up and you are outside with
no obstructions overhead.
no obstructions overhead.
U
“Specifying a GPS (GPS Positioning)” on
page 29
❏ It usually takes less than two minutes to
complete GPS positioning.
If GPS positioning is not complete after two
minutes or Failed is displayed, we recommend
selecting Cancel, moving to a different
location, and trying again.
minutes or Failed is displayed, we recommend
selecting Cancel, moving to a different
location, and trying again.
Operation buttons
A
Display the measurement screen.
Press C on the time screen.
GPS positioning starts, and the measurement
screen is displayed once positioning is complete.
screen is displayed once positioning is complete.
Note:
❏ You can skip GPS positioning if you want to
start measuring immediately or if it is taking
too long.
too long.
U
“Skipping GPS positioning” on page 30
❏ Use indoor mode when GPS positioning
cannot be performed because you are inside
and so on.
and so on.
U
“Indoor mode (SF-710/SF-510 only)” on
page 31
B
Displays the Mes. Settings menu.
Hold down B on the measurement screen.
C
Select Target Pace.
Use C/D to select, and then press A.
SF-710/510/310 User's Guide
Measure
61