Seiko Epson Corporation AP003 Manual De Usuario
Enabling the HR Monitor
When using the HR monitor, set HR to ON from the
Mes. Settings
Mes. Settings
menu.
c
Important:
❏ When performing GPS positioning, make sure
the screen is facing up and you are outside with
no obstructions overhead.
no obstructions overhead.
U
“Specifying a GPS (GPS Positioning)” on
page 29
❏ It usually takes less than two minutes to
complete GPS positioning.
If GPS positioning is not complete after two
minutes or Failed is displayed, we recommend
selecting Cancel, moving to a different
location, and trying again.
minutes or Failed is displayed, we recommend
selecting Cancel, moving to a different
location, and trying again.
Operation buttons
A
Display the measurement screen.
Press C on the time screen.
GPS positioning starts, and the measurement
screen is displayed once positioning is complete.
screen is displayed once positioning is complete.
Note:
❏ You can skip GPS positioning if you want to
start measuring immediately or if it is taking
too long.
too long.
U
“Skipping GPS positioning” on page 30
❏ Use indoor mode when GPS positioning
cannot be performed because you are inside
and so on.
and so on.
U
“Indoor mode (SF-710/SF-510 only)” on
page 31
❏ Screens are explained using the default
screens. You can invert the screen's
monochrome display.
monochrome display.
U
“Sys. Settings” on page 95
B
Displays the Mes. Settings menu.
Hold down B on the measurement screen.
C
Select HR.
Use C/D to select, and then press A.
D
Select ON.
Use C/D to select, and then press A.
SF-710/510/310 User's Guide
Measuring Heart Rate (HR Monitor)
70