NEC Corporation FC-N22A Manual De Usuario

2.13.1 Installing/Removing HDD/Silicon Disks

Removal

Turn off the power of N22A if operated.

Unplug the power cord from the AC outlet and remove the AC adapter from N22A.
When using a car adapter, unplug it from the cigar lighter receptacle and then remove the
car adapter from the N22A.

Remove the battery pack from N22A.
See

“Replacing Battery” in “Chapter 2 Uses of N22A”for the removal products.

Remove the anti-theft screws if they are to be used.

While pressing the button of the HDD/silicon disk cover on the right side, slide the
cover upward to open it.

Hold the HDD removal support and then pull out the HDD horizontally.

Installation

Insert a hard disk/silicon disk assembly into the disk storage area until it is securely
connected.

Close the cover, and then press down the part slid to the original position.

Attach the anti-theft screws if they are to be used.

Install a battery and connect an AC adapter or car adapter.

HDDs are extremely precise equipment. Note the following if used.

 During data read/write (with the access lamp being ON), only a small shock may cause the

HDD to be defected.

 If the HDD is defected, important data may be unavailable at a time and unable to be restored.

It is recommended to frequently back up important data for which the same data cannot be
created twice.

 Depending on models of HDDs, a region with no drive number assigned appears in the [Disk

Management] dialog box. This is the re-setup region required for re-setup. Do not provide the
region with such processing as deletion from targets of disk management.

Put the cover so that the HDD removal support may not be caught.

The HDD/silicon disk cannot be inserted in the wrong direction (upside down). Carefully
check its direction.