f.u.n.k.e. AVIONICS GmbH FSG90 Instrucciones de operación
FSG 90 System
5. Set-up Procedure
November 2000
Page
37
W. Dittel GmbH
S
ECTION
5
S
ET
-U
P
P
ROCEDURE
This section contains a description of the SET-UP procedure to be carried out by an
experienced avionics technician. To carry out the SET-UP procedure the radio must
be completely wired and ready to use.
experienced avionics technician. To carry out the SET-UP procedure the radio must
be completely wired and ready to use.
DANGER!
• During SET-UP procedure the radio is partly unable to work. The
• During SET-UP procedure the radio is partly unable to work. The
radio can neither receive nor transmit!
• NEVER carry out a SET-UP during flight or whilst driving a car!
Perform SET-UP only whilst standing safely on the ground!
• Before the next flight or application check all settings of the radio
and cockpit instruments for correct function!
IMPORTANT!
• The FSG 90(X) is factory pre-set for check and testing purposes. To
• The FSG 90(X) is factory pre-set for check and testing purposes. To
achieve maximum performance it is therefore absolutely necessary to
optimize the radio and to adapt the accessories used.
optimize the radio and to adapt the accessories used.
• To carry out the set-up the radio must be ready for operation (antenna
connected, power supply OK, operational microphone/s, headset/s).
• If headsets are used turn theirs volume control to maximum, if
applicable.
• All frequencies, channel names, channel memory numbers etc., shown in
the following illustrations, are examples!
The following settings can be selected or adjusted (order):
1.
Adjusting the automatic squelch threshold
2.
Adjusting the microphone sensitivity
3.
Adjusting the Intercom volume (headset)
4.
Adjusting the Transmit Sidetone volume (headset)
5.
Adjusting the headset volume (during Receive, independent from
speaker volume)
speaker volume)
6.
Selecting '25 kHz only' channel spacing or combined 8.33 kHz / 25 kHz
channel spacing. Confirmation with STO starts new mode at once.
channel spacing. Confirmation with STO starts new mode at once.
7.
Deleting occupied channel memories (one after the other)
8.
Selecting AF External via A/C speaker ON (1) or OFF (0).
9.
Selecting 'CHANNEL MODE' only (1) or 'Free Frequency Selection' (0)
10.
Selecting 'Transmitter Blocking' during receive ON (1) or OFF (0)
11.
Service, ON (1) or OFF (0)
12.
Optional module, ON (1) or OFF (0)
13.
Entering a password: protects against unauthorized changes of the
radio parameters.
radio parameters.