Park Air Systems Limited B6350 Manual De Usuario
TO INITIATE AN INTERRUPTIVE BIT TEST
Use the following procedure to initiate an interruptive BIT test from the transmitter's front panel. A BIT
test cannot be initiated while the transmitter is keyed.
test cannot be initiated while the transmitter is keyed.
1.
From the Main screen, press the switch to
display the Options menu. Turn the switch
until BIT is highlighted. Press the switch.
display the Options menu. Turn the switch
until BIT is highlighted. Press the switch.
2.
Ensure the BIT menu is displayed. Turn the
switch until BIT Initiate is highlighted, then
press the switch.
switch until BIT Initiate is highlighted, then
press the switch.
3.
During the test, which takes approximately
two
two
seconds,
the
Testing
screen
is
displayed.
4.
When the test has finished, check that the transmitter's front panel Alarm indicator is not lit. After a
BIT test, BIT screens are automatically displayed. The screens are shown on the next page.
BIT test, BIT screens are automatically displayed. The screens are shown on the next page.
T6T AM-Voice Operation
Section 2
Page 37
F r e q u e n c y
C h a n n e l
C o n f
i g u r e
B I T
E x i
t
B I T
I n i
t
i a t e
B I T
V i e w
B a c k
E x i
t
T e s t
i n g
P l e a s e
W a i
t
During an interruptive BIT test, the transmitter radiates a modulated carrier wave. Users
should therefore obtain the necessary authority before initiating a test.
Users should ensure a load is connected to the transmitter's antenna connector,
and note that the BIT circuits apply a signal to the audio input lines during a test.