Digital Monitoring Products Inc 1122 Manual De Usuario
1122 INSTALLATION GUIDE | DIGITAL MONITORING PRODUCTS
3
MOUNTING HOLES
Prior to permanently mounting the 1122, check that it is properly
communicating with the panel. See the Select a Location and Test
Communication to the Panel sections.
1. Remove the holding screw at the lower end of the 1122
case and gently lift off the cover.
2. Loosen the screw located on PCB and slide the PCB out of
the unit.
3. Place the 1122 against the wall and screw through the
appropriate mounting holes.
Flat Wall: For flat wall installations, choose from the
Flat Wall: For flat wall installations, choose from the
mounting hole locations shown in Figure 3. Be sure to
insert a screw in the tamper mounting hole.
insert a screw in the tamper mounting hole.
Corner:
For corner installations, choose from the mounting
hole locations shown in Figure 4. Be sure to insert screws
in the tamper mounting holes.
4. Reinstall the PCB back into the unit. Tighten the PCB
screw to secure it into place.
5. Place the cover back onto the 1122 and tighten the holding
screw back into place.
5
MOUNT THE 1122
REPLACE THE BATTERY
1. Remove the holding screw at the lower end of the 1122 case and
gently lift off the cover.
2. Remove the old battery and dispose of it properly. See Figure 2 for
the battery location.
3. Observing polarity, place the new battery in the holder and press
into place.
Note: Use only 3V Lithium CR123 batteries.
4. Place the cover back onto the 1122 and tighten the holding screw
back into place.
Caution: Properly dispose of used batteries. Do not recharge,
disassemble, heat above 212°F (100°C), or incinerate. Risk of fire,
explosion, and burns.
Sensor Reset to Clear LOBAT
When the battery needs to be replaced, a
LOBAT message will display on
the keypad. Once the battery is replaced, a sensor reset is required at the
system keypad to clear the
LOBAT message.
1. On a Thinline keypad, press and hold “2” for two seconds. On a
touchscreen keypad press
RESET.
2. Enter your user code if required.
3. The keypad displays
3. The keypad displays
SENSORS OFF followed by SENSORS ON.
Figure 4: Corner Mounting
Hole Locations
Tamper
Mounting Hole
Figure 3: Flat Mounting
Hole Locations
Tamper
Mounting
Holes