Digital Monitoring Products Inc PC0114 Manual De Usuario

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference, and 

(2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications made by the user and not expressly approved by the party responsible for compliance could 

void the user’s authority to operate the equipment.
Note:  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 

to part 15 of the FCC Rules.  These limits are designed to provide reasonable protection against harmful 

interference in a residential installation.  This equipment generates, uses and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may cause harmful interference 

to radio communications.  However, there is no guarantee that interference will not occur in a particular 

installation.  If this equipment does cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by 

one or more of the following measures:

-  Reorient or relocate the receiving antenna.

-  Increase the separation between the equipment and receiver.

-  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-  Consult the dealer or an experienced radio/TV technician for help.

Note: The 1100 Series wireless system is a two-way supervised wireless design.  It is compliant with FCC rules as 

they pertain to 900 MHz Spread Spectrum devices.  In rare instances it has been observed that certain 900 MHz 

cordless telephones may occasionally experience a clicking sound on the telephone while in use.  If this occurs, it 

may be resolved by selecting a different channel on the cordless telephone, or replacing the cordless phone with a 

different brand or model of 900 MHz telephone or other cordless telephone.
To comply with RF exposure requirements, a minimum separation distance of 20cm must be maintained between the 

antenna and all persons.