Digital Monitoring Products Inc PC0128 Manual De Usuario
Digital Monitoring Products
XT30/XT50 Installation Guide
14
InstallatIon
Reset Header J16
15.1 Description
The reset header is located just above the terminal strip on the right side of the circuit board and is used
to reset the XT30/XT50 microprocessor. To reset the panel when first installing the system, install the reset
jumper before applying power to the panel. After connecting the AC and battery, remove the reset jumper.
To reset the panel while the system is operational, for example, prior to reprogramming, install the reset
To reset the panel while the system is operational, for example, prior to reprogramming, install the reset
jumper without powering down the system. Remove the reset jumper after one or two seconds.
After resetting the panel, begin programming within 30 minutes. If you wait longer than 30 minutes, reset
After resetting the panel, begin programming within 30 minutes. If you wait longer than 30 minutes, reset
the panel again.
XT30/XT50 Panel
J3
Phone Line
Outputs
J11
1
2
3
4
J20
Wireless
Antenna
connection
J7 RJ
Supervision
J24 Celllular
header
Momentarily
place the Reset
jumper over both
of the J16 pins to
reset the panel.
J16
Reset
J18
Load
J1
Ethernet
OVC LED
Power
LED
TX RX
Wireless LEDs
Programming
J8
XMIT
RCV
Figure 8: Panel Showing the Reset Header