Digital Monitoring Products Inc PC0159 Manual De Usuario

20

12

Fiji, Marshall Island, Wellington, Auckland, Kwajalein, Kamchatka

13

New Cadelonia

14

Guam, Sydney

15

Tokyo, Seoul

16

Hong Kong, Singapore

17

Bangkok, Hanoi

18

Dhaka, Almaty

19

Islamabad, Karachi

20

Abu Dhabi, Kazan

21

Moscow, Bagdad

22

Eastern Europe

23

Rome, Paris, Berlin

This option allows local U.S.A. weather updates to display on the keypad. Enter the zip

code of the user at this prompt. When no number is entered weather conditions are not

displayed. Default is 0 (zero).

This section allows you to program communicator output options. Switched Ground

(open collector) outputs are available using terminals O1 and O2 as the ground and your

burglary control panel for power. Select from outputs 1 or 2.

This option allows you to define the operation of the two on-board outputs. For each

programming option, enter the number of the output you wish to activate or 0 (zero) for

no output. Either or both of the available outputs can be programmed here to turn off

after the time specified in Output Cutoff Time. To disable this option, press any Select

key to clear the display of output numbers and then press COMMAND.

If a Cutoff Output is assigned, you can enter a Cutoff Time for the output to remain

on up to 15 minutes. If the output is turned off manually, the cut off time is reset. The 

Cutoff Time can be 1 - 15 minutes. Enter 0 (zero) to provide continuous output.

Note: The output is cutoff within 60 seconds of the programmed cutoff time.

The Cutoff Timer is shared by all outputs. If a second output trips, the timer is not 

reset. Both outputs turn off when the original time expires.

This Output/Favorite turns on when the communicator fails to communicate with the 

receiver after three successive dial attempts. Enter 0 (zero) to disable this output. To

turn off the Communication Failure Output, disarm the communicator.

Note: Favorites are only available on the CellComSLCZ Communicator.

This Output/Favorite turns on any time an area of the system is armed. The output turns

off when the system completely disarms. Enter 0 (zero) to disable this output.

Enter the desired temperature setting for all Z-Wave thermostats when the system

is armed ALL or AWAY. When the system is disarmed the thermostats return to their

previous settings. The range is 55-95 degrees. Enter 0 (zero) to disable.

Enter the desired temperature setting for all Z-Wave thermostats when the system

is armed ALL or AWAY. When the system is disarmed the thermostats return to their

previous settings. The range is 55-95 degrees. Enter 0 (zero) to disable.

 

ENTER WEATHER 

ZIP CODE:   

0 

OUTPUT OPTIONS

CO OUTS: - - -

CUTOFF TIME:  0

COM FAIL OUT: 0

ARMED OUT:   

0

HEAT SAVER
TEMPERATURE: 0

COOL SAVER
TEMPERATURE: 0