Digital Monitoring Products Inc PC0166 Manual De Usuario

These instructions cover installing the 1137 on an interior wall. Figures 2 and 3 

show the base housing inside and outside views.
Double-sided tape mounting

1. Install a 1/2” wide strip of double-sided tape (not included) in each of the 

indentations on the back of the base housing.

2. Remove the backing from the tape and place the housing in the desired 

location on the wall with the cover slot toward the bottom. See Figure 4.

1. Insert a flat screwdriver into the slot on the bottom of the 1137 cover 

housing and gently push down on the screwdriver handle while pulling the 

halves apart. See Figure 5.

2. Set aside the top housing containing the button and internal assembly.

3. Using two #6 Phillips head screws (not included), press through the 

depressions and mount the base to the wall. See Figure 2.

4. Align the top cover snap with the base and snap the bottom of the cover in 

place. See Figure 4.

Observe polarity when installing batteries. Use only 3.0 Vdc Lithium batteries, DMP Model CR123A, or the equivalent 

battery from a local retail outlet.
Note: When setting up a wireless system, it is recommended 

to program zones and connect the receiver before installing 

batteries in the Emergency Lights.

1. Remove the top housing containing the PCB and lens 

assembly. Insert a flat screwdriver into the slot on the 

bottom of the housing and gently lift the screwdriver handle 

while pulling the halves apart. See Figure 5.

2. Using your hands, gently separate the top housing from the 

base.

3. Turn the top housing over and remove the old batteries. 

Dispose of the used batteries properly. See Figure 6 for 

battery location.

4. Observing polarity, place the 3.0 Vdc lithium batteries in 

the holders and press into place.

5. Snap the top housing back on to the base with PCB notch 

toward the top. See Figure 6.

 Caution: Properly dispose of used batteries. Do not 

recharge, disassemble, heat above 212°F (100°C), or 

incinerate. 

Risk of fire, explosion, and burns.

Typical battery life expectancy for DMP Model 1137 Emergency 

Light is 2 years. DMP wireless equipment uses two-way 

communication to extend battery life.
The following situations can reduce battery life expectancy:

• If a receiver is unplugged, or not installed. 

Note: Emergency Lights continue to send supervision messages until a receiver returns an acknowledgement. 

After an hour the Emergency Light only attempts a supervision message every 60 minutes.

• When installed in extreme hot or cold environments.

The following situation can extend battery life expectancy:

• Extend or remove Emergency Light supervision time in panel programming.

Top PCB 

Snap

Bottom 

PCB Snap

PCB 

Support

Serial 

Number 

Label

Battery 

Holders

PCB 

Support

Bottom 

Cover Snap

Top Cover 

Snap