Digital Monitoring Products Inc PC0179 Manual De Usuario

17

This section allows you to program communicator output options. Switched Ground

(open collector) outputs are available using terminals O1 and O2 as the ground and your

burglary control panel for power. Select from outputs 1 or 2.

This option allows you to define the operation of the two on-board outputs. For each

programming option, enter the number of the output you wish to activate or 0 (zero) for

no output. Either or both of the available outputs can be programmed here to turn off

after the time specified in Output Cutoff Time. To disable this option, press any Select

key to clear the display of output numbers and then press COMMAND.

If a Cutoff Output is assigned, you can enter a Cutoff Time for the output to remain

on up to 15 minutes. If the output is turned off manually, the cut off time is reset. The 

Cutoff Time can be 1 - 15 minutes. Enter 0 (zero) to provide continuous output.

Note: The output is cutoff within 60 seconds of the programmed cutoff time.

The Cutoff Timer is shared by all outputs. If a second output trips, the timer is not 

reset. Both outputs turn off when the original time expires.

This Output/Favorite turns on when the communicator fails to communicate with the 

receiver. Enter 0 (zero) to disable this output. To turn off the Communication Failure

Output, disarm the communicator.

Note: Favorites are only available on the iComSLCZ Communicator.

This Output/Favorite turns on any time an area of the system is armed. The output turns

off when the system completely disarms. Enter 0 (zero) to disable this output.

When the system is armed or disarmed remotely from the Virtual Keypad App, Virtual

Keypad Browser, MyAccess™, RemoteLink™ or from a schedule, this Output turns on

momentary for .75 seconds then turns off. This Output can be used for panels that

require a momentary short to an arming zone to arm and a momentary short to disarm.

Enter the desired temperature setting for all Z-Wave thermostats when the system

is armed ALL. When the system is disarmed the thermostats return to their previous

settings. The range is 55-95 degrees. Enter 0 (zero) to disable.

Enter the desired temperature setting for all Z-Wave thermostats when the system

is armed ALL. When the system is disarmed the thermostats return to their previous

settings. The range is 55-95 degrees. Enter 0 (zero) to disable.

This section allows you to assign functions to the burglary area of the communicator. 

All non-24-hour zones must be assigned to an active area. See section 14 on Zone

Information.

Enter the number of the area to program. Select from areas 1 to 6.

Only those areas given names can have zones assigned to them. All others are marked

*UNUSED*. Refer to the Entering Alpha Characters section.

To add an area name to the system, press any Select key and then enter up to 16

characters for the new name. Press COMMAND to continue.

To mark an active area as unused, delete the old name by pressing any Select key then

press the COMMAND key. The communicator automatically sets the name as *UNUSED*. If

you have already Initialized the communicator, all areas will be marked as *UNUSED*.

OUTPUT OPTIONS

CO OUTS: - - 

CUTOFF TIME:  

0

COM FAIL OUT: 

0

COOL SAVER

TEMPERATURE: 0

AREA INFORMATION

* UNUSED *

ARMED OUT:   

0

RMT ARMG OUT: 

0

HEAT SAVER

TEMPERATURE: 0

AREA NO: -