Embed International Pty Ltd STS101 Manual De Usuario
www.embedcard.com
12
FCC Part 15B Compliance Statement
RADIO AND TELEVISION INTERFERENCE
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving device.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
You may also find helpful the following booklet, prepared by the FCC: "How to
Identify and Resolve Radio-TV Interference Problems." This booklet is available
from the U.S. Government Printing Office, Washington D.C. 20402.
Identify and Resolve Radio-TV Interference Problems." This booklet is available
from the U.S. Government Printing Office, Washington D.C. 20402.
Any Changes or Modifications not expressly approved by Embed International or
registrant of this equipment can void your authority to operate this equipment under
Federal Communications Commissions rules.
registrant of this equipment can void your authority to operate this equipment under
Federal Communications Commissions rules.
This device complies with part 15 of the FCC Rules. Operation is subject to the
Following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation
Following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation
CE
– Declaration of Conformity
The smartTouch Swipe equipment meets the requirement of EC dircetives for CE
certification
certification
Directive 2014/53/EU the following standards are applied :
Standard
EN 60950-1: 2006+A11: 2009+A1:2010+A12:2011+A2:2013
ETSI EN 301 489-1 V
ETSI EN 301 489-1 V
2.1.1, ETSI EN 301 489-3 V2.1.1, ETSI EN 301 489-17
V
3.1.1, ETSI EN 300 328 V2.1.1, ETSI EN 300 330 V2.1.1, EN 62311:2008
To comply with FCC RF exposure compliance requirements, this grant is
applicable to only mobile configurations. The antennas used for this transmitter
must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.