Williams Sound T32 Manual De Usuario

INCIDENTAL OR CONSEQUEN-
TIAL DAMAGES CAUSED BY
ANY USE, DEFECT, FAILURE OR
MALFUNCTION OF THE PROD-
UCT, WHETHER A CLAIM FOR
SUCH DAMAGES IS BASED
UPON WARRANTY, CONTRACT,
TORT OR OTHERWISE.  THE
SOLE REMEDY FOR ANY
DEFECT, FAILURE OR MALFUNC-
TION OF THE PRODUCT IS
REPLACEMENT OF THE PROD-
UCT.  NO PERSON HAS ANY
AUTHORITY TO BIND WILLIAMS
SOUND TO ANY REPRESENTA-
TION OR WARRANTY WITH
RESPECT TO THE PFM T32
TRANSMITTER.  UNAUTHO-
RIZED REPAIRS OR MODIFICA-
TIONS WILL VOID THE WARRAN-
TY.

The exclusions and limitations set out
above are not intended to, and should
not be construed so as to contravene
mandatory provisions of applicable
law.  If any part or term of this
Disclaimer of Warranty is held to be
illegal, unenforceable or in conflict
with applicable law by a court of
competent jurisdiction, the validity of
the remaining portions of this
Disclaimer of Warranty shall not be
affected, and all rights and obligations
shall be construed and enforced as if

this Limited Warranty did not contain
the particular part or term held to be
invalid.
If you experience difficulty with your
system, call Toll-Free for Customer
Assistance:

If it is necessary to return the system
for service, your Customer Service
Representative will give you a Return
Authorization Number (RA) and
shipping instructions.

Pack the system carefully and 
send it to:

4

®

5

®

6

®

7

®

By default, the T32’s frequency
is to set 75.7 MHz (Channel G).
If you experience FM interfer-
ence, or if you need to match a
receiver’s frequency, it may be
necessary to adjust the frequency
on the T32. Instructions:

1. Open the battery compartment

using a coin in the slot in the
bottom of the transmitter.
Remove the batteries.

2. Lift the battery compartment

door up and pull to your left to
expose the circuit board.

3. Refer to FIG 4 to locate the

Channel Switch.

4. Use a small screwdriver to

rotate the Channel Switch to
correspond with the desired
operating frequency. Choose
between 16 standard channels.
Refer to the Channel Selection
Chart in FIG 3 for available
channels.

5. Reinstall the batteries, then

close the back of the transmitter.

6. Plug the microphone in and turn

the transmitter on to provide a
tuning signal for the receivers.  

. Refer to the

receiver’s instruction manual
for frequency change instruc-
tions.

If necessary, the microphone gain
control on the T32 can be
increased or decreased to meet
the demands of specific listening
applications.  

Instructions:
1. Open the battery compartment

using a coin in the slot in the
bottom of the transmitter.
Remove the batteries.

2. Lift the battery compartment

door up and pull to your left to
expose the circuit board.

3. Refer to FIG 4 to locate the

microphone gain control.

4. Using a small screwdriver, turn

the gain control fully counter-
clockwise to reduce the gain.
Turn the gain control fully
clockwise to increase the gain 

5. Close the back of the case and

battery door.

By default, the T32 transmitter
compression jumper is set to
“Off” for normal operation, or
1:1 compression. For hearing
assistance applications, the com-
pression jumper can be set to
“On” for 2:1 compression.  

Instructions:
1. Open the battery compartment

using a coin in the slot in the
bottom of the transmitter.
Remove the batteries.

2. Lift the battery compartment

door up and pull to your left to
expose the circuit board.

3. Refer to FIG 4 to locate the

Compression Selector.

4. Gently remove the jumper

from the circuit board by
pulling it up and away from
the unit. You will see three
exposed “pins.” 

To turn compression
“On” (2:1 Compression):
Press jumper on to the
top two

pin locations as

shown on left.

To turn compression
“Off” (1:1 Compression):
Press jumper on to the
bottom two

pin locations

as shown on left.

5. Close the back of the case and

battery door.

Williams Sound products are engi-
neered, designed and manufactured
under carefully controlled conditions
to provide you with many years of
reliable service.  Williams Sound
warrants the PFM T32 transmitter
against defects in materials and work-
manship for FIVE (5) years.  During
the first five years from the purchase
date, we will promptly repair or
replace the PFM T32 transmitter.  

WILLIAMS SOUND HAS NO
CONTROL OVER THE CONDI-
TIONS UNDER WHICH THIS
PRODUCT IS USED.  WILLIAMS
SOUND, THEREFORE, DIS-
CLAIMS ALL WARRANTIES NOT
SET FORTH ABOVE, BOTH
EXPRESS AND IMPLIED, WITH
RESPECT TO THE PFM T32
TRANSMITTER, INCLUDING
BUT NOT LIMITED TO, ANY
IMPLIED WARRANTY OF MER-
CHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE.
WILLIAMS SOUND SHALL NOT
BE LIABLE TO ANY PERSON OR
ENTITY FOR ANY MEDICAL
EXPENSES OR ANY DIRECT,