Broadcast Microwave Services Inc CCII-9L Manual De Usuario
6051412900 Rev -
14
Mode (TX Robustness)
Preferred applications
Characteristics
LOW
Studio
Short transmission range.
Maximum video quality.
Maximum video quality.
MID
News, sports, entertainment
Medium transmission range.
High video quality.
High video quality.
HIGH
Mobile & airborne transmission (with
walls or buildings in the path)
walls or buildings in the path)
Long and/or difficult transmission.
Normal video quality.
Normal video quality.
The operator can define specific operating parameters (compression and transmission) via the EXPERT mode. See
section
section
0
Recalling and Saving Operating Configurations
The CARRY-CODER II provides the operator with the ability to save and recall 8 user-defined presets configurations. These
configurations are non-volatile (saved in an EEPROM) and are not lost when the system power is switched off. Each configuration
contains all of the CARRY-CODER operating parameters, so that recalling a user-defined configuration will restore the system
exactly in the same state as when it was saved.
Preset (stored) configurations are recalled using the following menu:
RECALL CONFIGURATION
1 2 3 4 5 6 7 8 9 default
1 2 3 4 5 6 7 8 9 default
To recall a configuration the user should select one of the preset memories or default then press < OK >.
Selecting the <default> will reset all settings back to the factory default.
Custom configurations are saved to memory using the following menu:
SAVE CONFIGURATION
1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
To save a configuration the user should first set the appropriate operating parameters to the desired state, then select one of the
preset (configuration) memories locations. In the following example, preset memory 2 is selected.
SAVE CONFIGURATION
1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
Then, press < OK > to save the configuration to the selected preset (memory): The Menu Edit mode is completed.
SAVE CONFIGURATION
1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
.
Be careful when recalling configurations: If a preset configuration includes RF OUTPUT POWER active, the CARRY-
CODER II finishes its initialization and transmits on the RF frequency that is saved in memory! In order to follow
accepted practice and to avoid unwanted transmission, good practice recommends that the preset configurations are
saved with the <RF Output Power> setting in the < OFF > condition.
CODER II finishes its initialization and transmits on the RF frequency that is saved in memory! In order to follow
accepted practice and to avoid unwanted transmission, good practice recommends that the preset configurations are
saved with the <RF Output Power> setting in the < OFF > condition.
Setting Video Input Parameters and Video Mode
The video input type is set through the following menu.
VIDEO INPUT
CVBS YUV SDI ASI
CVBS YUV SDI ASI