Chilin Electronics co. Ltd. ZBM2400 Manual De Usuario
ZBM-2400 User Manual
Chilin Electronics co ltd.
V1.0.1 Page 13
8
Example of installation
When put the module on the target PCB to perform ZigBee wireless transmission. Plug the module into
socket with correct direction shown below. The DIP-SW #1 & #4 should be set to on position and DIP-SW
#2 & # 3 should be set to off position. Make sure no ESD discharge happened.
socket with correct direction shown below. The DIP-SW #1 & #4 should be set to on position and DIP-SW
#2 & # 3 should be set to off position. Make sure no ESD discharge happened.
When power on, the green LED on the module will be flashing (power), then the red LED also flashing (data
received), about 7 seconds later, the clock will be synced to master clock.
Put the
end up
which chip
antenna
mounted.
end up
which chip
antenna
mounted.
ZigBee
module
module