Tecom Co Ltd D1021 Manual De Usuario

Notice : The changes or modifications not expressly approved by the party responsible 

for compliance could void the user’s authority to operate the equipment. 

IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no 

change to the antenna or the device is permitted. Any change to the 

antenna or the device could result in the device exceeding the RF 

exposure requirements and void user’s authority to operate the device. 

FCC INFORMATION

 

 

The Federal Communication Commission Radio Frequency Interference 

Statement includes the following paragraph: 

 

The equipment has been tested and found to comply with the limits for a Class 

B Digital Device, pursuant to part 15 of the FCC Rules.    These limits are designed 

to provide reasonable protection against harmful interference in a residential 

installation.    This equipment generates, uses and can radiate radio frequency 

energy and, if not installed and used in accordance with the instruction, may cause 

harmful interference to radio communication.    However, there is no grantee that 

interference will not occur in a particular installation.    If this equipment dose cause 

harmful interference to radio or television reception, which can be determined by   

turning the equipment off and on , the user is encouraged to try to correct the   

interference by one or more of the following measures: 

--Reorient or relocate the receiving antenna. 

--Increase the separation between the equipment and receiver. 

--Connect the equipment into an outlet on a circuit different from that to which the 

  receiver is connected. 

--Consult the dealer or an experienced radio/TV technician for help. 

IMPORTANT NOTE: 

To comply with the FCC RF exposure compliance requirements, the antenna(s) used for this 

transmitter must be installed to provide a separation distance of at least 20 cm from all persons 

and must not be co-located or operating in conjunction with any other antenna or transmitter. 

No change to the antenna or the device is permitted. Any change to the antenna or the device 

could result in the device exceeding the RF exposure requirements and void user’s authority to 

operate the device.