Lectrosonics Inc SMWBC1 Manual De Usuario
Digital Hybrid Wireless Belt-Pack Transmitters
Rio Rancho, NM
25
Transmitter
Operating Frequencies:
Band A1:
470.100 - 537.575
Band B1:
537.600 - 614.375
Band C1:
614.400 - 691.175
Frequency Selection Steps:
Selectable; 100 kHz or 25 kHz
RF Power output:
25, 50 or 100 mW
Pilot tone:
25 to 32 kHz; 5 kHz deviation
(Digital Hybrid mode)
Frequency Stability:
± 0.002%
Deviation:
± 75 kHz max. (Digital Hybrid mode)
Spurious radiation:
60 dB below carrier
Equivalent input noise:
–120 dBV (A-weighted)
Input level:
Nominal 2 mV to 300 mV, before limiting
Greater than 1V maximum, with limiting.
Input impedance:
• Mic: 300 Ohm
• Line: 2k Ohm
Input limiter:
DSP controlled, dual envelope “soft” limiter
with greater than 30 dB range
Gain control range:
44 dB; digital control
Modulation indicators:
• Dual bicolor LEDs indicate modulation of
-20, -10, 0 and +10 dB referenced to full
modulation
• LCD bar graph
Controls:
Side panel membrane switches with LCD
interface for power on/off and all setup and
configuration controls
Audio Input Jack:
Switchcraft 5-pin locking (TA5F)
Audio Performance (Digital Hybrid mode)
Frequency Response:
Frequency Response:
Mic input:
35 Hz to 20 kHz (+/-1dB); low frequency
roll-off is selectable at 35, 50, 70, 100, 120, 180 Hz
Line/Instrument:
35 Hz to 20 kHz (+/-1dB)
THD:
0.2% (typical)
SNR at receiver output:
Note: The dual envelope “soft”
limiter provides exceptionally good
handling of transients using variable
attack and release time constants. Once activated, the limiter compresses 30+ dB
of transmitter input range into 4.5 dB of receiver output range, thus reducing the
measured figure for SNR without limiting by 4.5 dB
SmartNR
No Limiting
w/Limiting
OFF 103.5 108.0
NORMAL 107.0
NORMAL 107.0
111.5
FULL 108.5 113.0
Specifications subject to change without notice.
Antenna:
Galvanized steel, flexible wire
Battery:
Two AA lithium, disposable
Battery Life w/ Lithium AA:
SMWB 50 mW (1 AA):
7.25 hrs
SMWB 100 mW (1 AA):
5.5 hrs
SMDWB 50 mW (2 AA):
14.5 hrs
SMDWB 100 mW (2 AA):
14 hrs
Weight:
5.8 ounces (141 grams), including lithium AA batteries
Dimensions:
3.2 x 2.4 x .9 in. (81 x 61 x 20 mm)
Emission Designator:
180KF3E
Specifications subject to change without notice.
Specifications
Recorder
Recording
Storage media:
microSDHC memory card*
File format:
.wav files (BWF - Broadcast Wave File)
A/D converter:
24-bit (with additional 8 bits for wav format
compatibility)
Sampling rate:
44.1 kHz
Recording mode/Bit rate:
HD mono mode; 24 bit - 132 kbytes/s
Input
Type:
Analog mic/line level compatible;
servo bias preamp for 2V and 4V lavaliere
microphones
Input level:
• Dynamic mic: 0.5 mV to 50 mV
• Electret mic: Nominal 2 mV to 300 mV
• Line level: 17 mV to 1.7 V
Input connector:
TA5M 5-pin male
Audio Performance
Frequency response:
20 Hz to 20 kHz; +0.5/-1.5 dB
Dynamic range:
110 dB (A), before limiting
Distortion:
< 0.035%
Operating temperature range
Celsius:
-20 to 50
Fahrenheit:
-5 to 122
Specifications subject to change without notice.
*microSDHC Logo is a trademark of SD-3C, LLC