3Com Corporation WL311 Manual De Usuario
5
Troubleshooting Bridge Problems
40
Handling Event Log Errors
The following table lists event log errors. (See “Using the Log Viewer” on page 33 for
more information about accessing the event log.) All entries in the event log are preceded
by a number. This number is a time stamp used by Customer Support, but is not relevant
to looking up items in this table.
more information about accessing the event log.) All entries in the event log are preceded
by a number. This number is a time stamp used by Customer Support, but is not relevant
to looking up items in this table.
Handling Terminal Configurator Error Codes
See Appendix B, “Using the Terminal Configurator,” for detailed information about using
the Terminal Configurator method to configure your 3Com Wireless Building-to-Building
Bridge.
the Terminal Configurator method to configure your 3Com Wireless Building-to-Building
Bridge.
Error Code
Description
UART Error – No Rx Buffer
Available
Available
Data is being sent to the UART at a rate faster than it can clear its receive buffers, and data is being lost.
Note that if you are using the serial port menu system for configuration, flow control will not be
enabled in the wireless bridge. To avoid getting this error while in the serial port configuration system,
simply type slower.
enabled in the wireless bridge. To avoid getting this error while in the serial port configuration system,
simply type slower.
Initialization of interface
"lan0" failed.
"lan0" failed.
The bridge could not be initialized.
Try each of the following steps in order. If any of these steps succeeds, there is no need to perform any
of the later steps; otherwise continue to the next step.
of the later steps; otherwise continue to the next step.
1 Reset the wireless bridge.
2 Unplug the power, wait for approximately 30 seconds and then reapply power.
3 Reset the wireless bridge to the factory default configuration and reset the wireless bridge.
4 Contact 3Com Customer Support if the problem persists.
Error Code
Description
Xxxx: [yyyy]:
section does not exist
Section named yyyy in configuration file named xxxx was missing.
Save your current configuration (if applicable). Reset the wireless bridge configuration to factory
defaults. Reset the wireless bridge. Restore configuration (if applicable).
defaults. Reset the wireless bridge. Restore configuration (if applicable).
Xxxx: [yyyy]: “zzzz”:
entry refers to non-existent
section
section
Entry zzzz refers to a section that is not located in file xxxx.
Save your current configuration (if applicable). Reset the wireless bridge configuration to factory
defaults. Restore configuration (if applicable).
defaults. Restore configuration (if applicable).
Xxxx: [yyyy]: "zzzz":
entry does not exist
Entry zzzz in section yyyy of file xxxx was missing.
Save your current configuration (if applicable). Reset the wireless bridge configuration to factory
defaults. Reset the wireless bridge. Restore configuration (if applicable).
defaults. Reset the wireless bridge. Restore configuration (if applicable).
Xxxx: [yyyy]: "zzzz":
entry is invalid
Entry zzzz in section yyyy of file xxxx contains an invalid value.
Check the entry in the configuration for zzzz. If you cannot find zzzz in the wireless bridge Bridge
Manager program, you may have to use the serial port or Telnet configuration menus.
Manager program, you may have to use the serial port or Telnet configuration menus.
Xxxx: <[yyyy]zzzz>:
Unable to add route.
Route values are out of range compared to the interface values.
Set the route value to “automatic.” If “automatic” does not work for your wireless bridge, check the
values you set for the route to make sure they correspond to your other IP parameters.
values you set for the route to make sure they correspond to your other IP parameters.
Xxxx: file does not exist.
Configuration file could not be found.
Reset the configuration to factory defaults, and reset the wireless. If the problem persists, contact
3Com Customer Support.
3Com Customer Support.